Rgb-spectrum Quadra User's Guide Manual de usuario descargar pdf (Pagina 34)

INSTALLATION AND SETUP

System Timing

350-7951 Quadra User’s Guide 26

. . . . .

7. With the upper-left corner properly adjusted, adjust the lower-right

corner next by using the following keyboard controls. The goal is to

position this corner for maximum image visibility.

I = move up J = move left

M = move down L = move right

8. To exit the function, type q. This returns the system to the “normal”

command mode of operation.

9. Repeat steps 5 through 7 for the selected input. This repetition is

necessary to accurately fine-tune the timing parameters.

10. Use the Input Name function to name the input source, up to 23

alphanumeric characters in length. Spaces are not allowed in the

name, but underscores and upper/lower case characters are OK. Type:

INN <input#> <name> Enter

S Example: To name input 1 “PowerPoint_1,” type:

INN 1 PowerPoint_1

11. Use the Input Save function to store the selected input’s parameters in

one of 61 slots in the Input List. These settings are recalled whenever

the signal is reapplied to the Quadra. Type:

INS <input#> <100 ... 160> Enter

S Example: To save input 1 in Input List slot 101, type:

INS 1 101

This completes the procedure for adjusting, naming and saving the

selected input.

12. Repeat steps 4 through 11 for all remaining Quadra inputs.

Note These commands are all upper case.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 131 132

Sin comentarios

Rgb-spectrum Quadra User's Guide Manual de usuario Pagina 34